Submersible Pump
Back

"WET TYPE SUBMERSIBLE PUMP SPEED 2880 RPM 0.5 H.P to 75 H.P"

Suitable for 4 inch,6 inch & 8 inches Borewells

  • MOTOR
    "ATLANTIC"Submersible motor is awet type aquirrel cage induction motor of 2880 R.P.M., suitable for 415v, 50 Hz, 3 phase, A.C. supply. The winding are made of water proof P.V.C. Insulated Copper wires. The motor shaft is guided by sleeve bearings of special lead bronze having extremely high wearing capacity. The axial thrust produced by the pumps and rotor are taken care of by means of single tilting pad thrust bearing. The winding and bearing bushes are cooled and lubricated by pure water filled in the motor before erecting the pumpset. The motor is protected from well water, sand and foreign matters by means of cable gland and rubber seal etc. The thrust bearing housing is provided with a drain plug for filling and draining of water.

  • PUMP
    The pumps is multistage type of latest hydraulic design for maximum performance and operating efficiency. The casings are made of close grained graded grey iron casting. Impellers are made of high quality bronze and are dynamically balanced, The stainless steel shaft is lapped to close tolerances, guided by Water lubricated rubber bearings, provided in each bowl of impeller casing. A strainer is provided at into the suction casing. A non-return valve is provided just below the rising main. Hydrostatic test is conducted on each pumpset at 2 times the maximum discharge pressure.
    "ATLANTIC" pumpsets are manufatured and tested conforming to IS : 8034-1989, specification for submersible pumpsets for clear, cold, fresh water.